Precast Systems

The Precast Column is a vertical structural member which can be 1 or 2 tiers. Columns use pre-fabricated cages, while walls, precast household shelters and slabs utilize mesh for reinforcement.

he Precast Staircase offers consistent step dimensions and a good surface finish.

A floor/ceiling structure made of reinforced concrete floor planks assembled on the ground or offsite, then put into place. The concrete floor planks are supported by a bearing wall.

The Precast Duct not only acts as a coverup to all conduits services but also contribute to the architectural aspects and can also be done on different finishes.

It is a horizontal external slab for holding the aircon FCU. The aircon ledge is exposed to severe weather conditions hence more extensive surface waterproofing is employed

The Precast Chamber is part of vertical precast components for disposal of waste. It is anchored to adjacent beams, walls and slabs at each floor by its loop bars.

Prefabricated bathroom unit (PBU) refers to a bathroom unit preassembled off-site complete with wall and floor finishes, sanitary wares, concealed pipes, conduits, cabinets and a ceiling before installing into position. By using PBUs, there is a 40% to 60% improvement in productivity and time usage, reducing the overall cost of the project. Our versatile PBUs are truly innovative and are developed with the requirements of architects, developers and contractors in mind.

Precast wall is strongly recommended specially for external wall construction as low cement ratio are commonly used which helps in terms of water tightness as well as minimal joints used during construction

The Precast Beam is designed & cast according to shapes that will contribute to architectural works & even can be designed to integrate with other components adjacent to it like wall partitions & facades.

The Household Shelter in a dwelling unit is a volumetric bomb shelter for civil defence requirement and is typically the store-cum-pantry with its walls, floor and ceiling strengthened with increased thickness.

Precast balconies are designed and manufactured to any custom shape and design. Often with a sloped top surface, step down and a drip edge on the underside for proper drainage and water run-off step.

The Precast Facade is designed as a non-critical panel & it allows architects much greater freedom in exercising their creativity, where certain shapes & expressions are difficult or no possibility to construct without precasting.

The Parapet is a half-height wall, usually enclosing a roof, or a protective barrier at the edge of a terrace or on the side of a bridge. Some parapet walls also have handrails installed.

The Gable End Wall is cast with insulation. It is sometimes integrated with a column to form a plane.

The Precast Water Tank is for domestic and firefighting purposes. We also provide precast ring water tank depending on the configurations of water tank components. It is more durable than steel and fibre-reinforced plastic water tanks.

The Precast Door Frame Panel is a steel door frame installed with ventilation sleeves and reinforcement bars for joining wall panels.

It is a vertical structural member and used as a staircase wall.